Scott Hyland preparing a transducer to be installed into the hull.

Dinky applying resin to foam board so future fiberglass will adhere to it.

    

Kevin preparing stern seat for installation.

Chris refitting the generator hatch and preparing it for upcoming flooring.

Tony installing the electronic fuel tank senders.  These indicate the amount of fuel in tanks.

Stern seat left with tools on it, collar board center, and rear deck being roughed-in on right.

Cockpit hatch with shelf installed.

Foreground is the cockpit roof and rear of salon roof (white).  In rear of picture is the flybridge canopy being

manufactured (grey).

Dinky gelcoating the salon wall above what will be the dinette table. 

We are hoping the windows come in real soon.  Note the end of the second section of the salon roof overhead. This is where the third section will join the second section real soon and then extend over the cockpit.  The hole/channel in the middle of the roof will run from the front of the salon to the rear of the cockpit.  This channel is an electrical chase to run future wiring and lighting.